Bulldog Seal: Wall & Brick Applications

Wall, Brick & Block Applications include sealing stone, porous concrete, brickwork and masonry. Bulldog Seal may also be used to seal cracks in wall surfaces.

Instructions for use:
Remove old paint and loose material with a wire brush. Remove dust by brushing with a wet paintbrush.

Small cracks (<2mm) may simply be painted over (dampen brush afterwards with clean water and use this to smooth the surface if required).

Large cracks (>2mm): Mix Bulldog Seal with clean fine plaster sand to form a stiff paste. Fill cracks using a flat-ended scraper. Allow to dry for two hours. Over-coat with normal Bulldog Seal compound.

Sealing stone, porous concrete, brickwork and masonry:
1. Remove old waterproofing.
2. Clean surfaces with a wire brush. Using a hose pipe, spray wall with clean water.
3. Dilute Bulldog Seal 50:50 with water and apply as a primer.
4. Allow to become touch-dry.
5. Paint one coat of Bulldog Seal at 1 litre per square metre.
6. When dry, it may be over-coated with normal wall finishes, although it is not necessary.